Quick fixes for iPhone 6s Screen Replacement

The iPhone 6s is one of the best models in the market, but also the most delicate and easy to drop, due to its smooth, thin design. A lot of people do not like to put a case on their iPhone 6s as they think that it ruins the sleek look, but unfortunately, this leaves the phone vulnerable to a lot of damage.

The iPhone 6s screen consists of the glass panel, digitiser and LCD screen, which are all bonded together. This means that if one part of the screen breaks, the damage is likely to spread and the whole screen will need to be replaced.

During the iPhone 6s screen replacement, we will take the iPhone parts and replace the display and the glass panel, digitiser and LCD screen. As we replace the full screen, we are able to change the original colour of the screen to the colour of your choice.

Discharge your battery below 25% before removing from your iPhone. A charged lithium-ion battery may explode. Turn off iPhone 6s before you start. Remove the two 3.4 mm P2 Pentalobe screws next to the lightning connector at the bottom edge of the iPhone.

Opening the display on the iPhone 6s separates a thin strip of adhesive around the perimeter of the display. If you prefer to change the glue, keep a bunch of new strips ready before proceeding. It is possible to complete the repair without replacing the adhesive and you probably will not find any difference in functionality.

Apply a suction cup to the lower left corner of the screen. Take care not to put the suction cup on the home button. Pull up the suction cup with a firm and constant pressure to create a slight gap between the front panel and the rear case.

Take your time and apply firm, constant force. The iPhone 6s screen replacement is tougher than most devices. Pulling too hard may damage the display. Apply just enough pressure to create a small gap between the display and the rear case.

There is a notch on the underside of the display, just above the headphone jack. This is the safest place to begin trying to open your iPhone 6s screen. Place the edge of a spudger directly on the headphone jack in the gap between the screen and the back case.

Insert the flat end of the spudger on the left side of the phone, between the display and rear case. Slide it up side to separate the adhesive and pop the clips free. After that, you need to place your new screen and fix it the same way which you have done to open your damaged iPhone 6s screen.

Use the flat end of a spudger or a fingernail to disconnect the digitizer cable by from its socket on the logic board.  When reconnecting the iPhone 6s digitizer cable, do not press the center of the connector. Press one end of the connector, then press the opposite end. Pressing the middle of the connector can bend the component and cause damage to the iPhone.

For more information on any of your iPhone repair needs, please visit our website at http://www.applerepairing.com.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s